Stihl TS 480i Manual De Instrucciones página 19

Cutting slabs
Place the slab securely on a non-
N
slip surface.
Cut a guiding groove (A) along the
N
marked line.
Cut deeper into the parting cut (B)
N
with uniform back-and-forth
movements.
Leave a ridge (C) of uncut material.
N
Cut through the slab at the ends so
N
the material does not chip.
Then break the slab.
N
TS 480i, TS 500i
Curves must be cut in several
N
straight passes, taking care to
ensure that the cutting wheel does
not become wedged.
Cutting round and hollow workpieces
Pipes and round objects, etc. must
N
be secured so that they cannot roll.
Avoid reinforcing elements,
N
especially in the direction of the cut,
when deciding on the cutting line.
Cut a guiding groove along the
N
marked line.
Cut deeper into the parting cut with
N
uniform back-and-forth movements.
Advance the cutting wheel along the
guiding groove at full cutting depth.
Always reposition the cutting wheel,
taking care not to wedge it, if the
cutting direction has to be corrected
slightly. If necessary, leave small
ridges of uncut material to hold the
severed part in position. These
ridges can subsequently be broken
through.
Cutting shapes on pipes
Mark the cutting line.
N
WARNING
Particular care and precision are
required for free-hand cutting along such
cutting lines. Avoid side-loading the
wheel or causing it to bind.
English
17