And Pull It Off To The Front; N Remove The Nuts - Stihl TS 480i Manual De Instrucciones

English
Removing the V-belt guard
2
1
Unscrew the screw (1) – screw (1) is
N
secured on the V-belt guard (2) to
prevent loss
Raise the V-belt guard (2) slightly
N

and pull it off to the front

3
Remove the V-belt (3) from the front
N
pulley (4)
24
Removing the "cast arm with guard"
1
Remove the nuts (1)
N
4
Remove the "starter cover with
N
rewind starter" (2)
Remove the "cast arm with
N
guard" (3) from the studs
Preparing the "cast arm with guard" for
outboard mounting
Unscrew the stop pin (1)
N
3
1
2
1
1
1
4 5
Turn the guard so that it is in the
N
position shown (see picture)
Screw in and tighten the stop pin (1)
N
Move the adjusting lever (2) to
N
position A
Screw in the bolt (3) and tighten up
N
Remove screw (4) from the limit
N
stop (5)
Pull off the limit stop (5)
N
6
4 5
Turn the "cast arm with guard" so
N
that the guard is on the outboard
side
Insert limit stop (5) – align the hole
N
in the limit stop with the hole in the
cast arm
Screw in the bolt (4) and tighten up
N
TS 480i, TS 500i
A
3 2