Stihl TS 480i Manual De Instrucciones página 12

English
and personal injury from fire may result.
Replace damaged or badly worn
brackets immediately.
Grip: Never use the cut-off machine with
one hand. Always hold the cut-off
machine firmly with both hands when the
engine is running. Place your left hand
on front handle bar and your right hand
on rear handle and throttle trigger. Left-
handed users should follow this
instruction too.
Wrap your fingers tightly around the
handles, keeping the handles cradled
between your thumbs and forefingers.
Make sure your cut-off machine handles
and grip are in good condition and free
of moisture, pitch, oil, fuel mix or grease.
Never touch a rotating wheel with your
hand or any part of your body.
WARNING
Clear the area where you are working.
Avoid stumbling on obstacles and watch
out for holes or ditches. Be extremely
cautious when working on slopes or
uneven ground. Take extreme care in
wet and freezing weather (rain, snow,
ice.)
10
WARNING
Sparks from cutting metal
can burn or cause cloth-
ing to catch fire. Always
direct sparks away from
the operator or any flam-
mable surroundings.
Never cut metal while
standing on a flammable
surface, such as wood or
tar paper. Where there is
a risk of fire, have appro-
priate fire extinguishing
equipment readily
available.
WARNING
To reduce the risk of injury from fire, do
not cut into any pipe, drum or other
container without first ensuring that it
does not contain a volatile or flammable
substance.
WARNING
When cutting into existing walls, floors or
similar structures, be alert for hidden
hazards such as electrical cables, water
and gas pipes and flammable
substances. Make sure that power,
water and gas have been shut off and
pipes drained before starting to cut.
Operating Instructions
WARNING
The wheel guard is adjustable. It is
extremely important that the wheel
guard is in place and set to suit the type
of work and your stance. The guard
should always be adjusted so that the
user is not endangered by particles of
the material being cut, sparks or pieces
of damaged wheels either directly or by
ricochet. Failure to follow this instruction
could result in serious or fatal injury.
WARNING
Your cut-off machine is equipped with a
wheel guard limit stop that restricts the
positioning of the wheel guard. To
reduce the risk of injury from wheel
contact and/or reactive forces and to
avoid damaging the guarding system,
never attempt to pull the adjusting lever
past the limit stop.
WARNING
Always check the wheel before use and
after unintentionally striking any object;
frequently check it during use when it is
stopped. Look for cracks and make sure
that it is undamaged and in good
condition and that no pieces have
broken off. See sections on "Abrasive
Wheels" and "Reactive Forces" in this
manual. Check the wheel guard for
cracks. If you discover any breaks or
cracks, fit a new guard before further
use.
WARNING
It is essential to determine the exact
direction of the cut before applying the
abrasive wheel to the work. Wheels are
constructed for radial pressure only.
Lateral pressure must be avoided. Hold
the cut-off machine steady. To reduce
the risk of serious or fatal injury, do not
change the direction of the cut during the
cut as this may produce a high torsional
load on the abrasive wheel and may
cause it to bind, break or shatter.
TS 480i, TS 500i