Sample Applications - Stihl TS 480i Manual De Instrucciones

snugly onto spark plug terminal of the
proper size. (Note: If terminal has a
detachable SAE adapter nut, it must be
attached.) A loose connection between
spark plug terminal and ignition wire
connector in the boot may create arcing
that could ignite combustible fumes and
cause a fire. Keep spark plug clean, and
make sure ignition lead is in good
condition.
WARNING
Do not operate your cut-off machine if
the muffler is damaged, missing or
modified. An improperly maintained
muffler will increase the risk of fire and
hearing loss. Never touch a hot muffler
or spill fuel or other flammable liquid
over it. Burn injuries or fire will result. If
your muffler was equipped with a spark-
arresting screen to reduce the risk of fire
(e. g. in the USA, Canada and
Australia), never operate your cut-off
machine if the screen is missing or
damaged.
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of the instruction
manual.
Store wheels on a flat surface in a dry
place, preferably at a constant
temperature, where there is not a risk of
frost. Do not store a cut-off machine with
a wheel mounted on the machine. Store
cut-off machine in a high or locked
place, away from children.
Empty the fuel tank before storing for
longer than a few days. Store fuel only in
correctly labeled and approved
containers. Avoid direct skin contact and
do not inhale the gas vapors.
TS 480i, TS 500i

Sample applications

Most diamond cutting wheels are
suitable for wet cutting
Wet cut whenever feasible. It increases
the service life and cutting speed of
diamond cutting wheels.
Ensure that the cutting wheel is
generously supplied with water.
Wet cutting helps to suppress dust.
The water binds the dust.
The cutting wheel must be supplied with
at least 20 fl. oz (0.6 liters) water per
minute.
Wet cutting can reduce the energy of
reactive forces. In a pinch situation, the
water can act as a lubricant.
Water connection
A water attachment kit is mounted
–
on the machine for use with all types
of water supply.
A pressurized 10 liter water tank is
–
available from STIHL for dust
suppression.
A water tank for mounting on the
–
Cutquik cart is also available for
dust suppression.
Composite resin wheels can be used for
dry cutting of metals or for wet or dry
cutting of concrete, stone or masonry.
Composite resin wheels designed for
dry cutting
Special procedures must be followed
when wet cutting with a composite non-
diamond wheel designed for dry cutting.
See the section entitled "Wet Cutting
with Abrasive Wheels" in the safety
precautions of this manual. Wet cutting
is generally not suitable for cutting
metals.
Composite resin wheels designed for
wet cutting
Adjust water flow rate
during cutting so it is suf-
ficient to bind all the dust
that occurs (at least
20 fl. oz (0.6 L/min)).
If the water flow rate is too high, the
cutting wheel may skim on the water
surface in the cut and greatly reduce
cutting performance. To avoid this, do
not exceed a water flow rate of about
135 fl. oz (4 L/min).
English
15