Replacing The V-Belt - Stihl TS 480i Manual De Instrucciones

Refit the starter cover
N
If the spring has popped out of the
N
spring housing: Refit it, working
from the outside inwards
TS 480i, TS 500i

Replacing the V-belt

2
1
1
1
Undo the nuts (1)
N
Turn the tensioning nut (2)
N
counterclockwise with the
combination wrench -
approx. 1/4 turn, as far as it will
go = 0
4
3
Pull the water hose out of the guide
N
in the V-belt guard
Unscrew the screw (3)
N
Raise the V-belt guard (4) slightly
N
and pull it off to the front
0
1
Remove the V-belt from the front
N
pulley
Remove the nuts (1)
N
Remove the starter cover (5)
N
Do not remove the "cast arm and
N
guard" (6) - hold it in place on the
studs until the starter cover is fitted
back in position
Remove the defective V-belt
N
8
Carefully insert the new V-belt (7)
N
on the V-belt pulley (8) on the
engine and the front V-belt
pulley (9)
NOTICE
The belt action must run smoothly.
English
6
1
5
1
9
7
37