Assembling The Cast Arm And Guard; N Turn The Tensioning Nut; Counterclockwise With The Combination Wrench - Approx. 1/4 Turn, As Far As It Will Go; N Unscrew The Screw - Stihl TS 480i Manual De Instrucciones

1 2
remove the coupling sleeve (1);
N
unscrew the "water connection with
N
screen" (2) and rinse under running
water – the screen remains on the
water connection.
TS 480i, TS 500i
Assembling the cast arm and
guard
The "cast arm with guard" is mounted on
the inboard side by the manufacturer.
The "cast arm with guard" can also be
mounted on the outboard side
depending on requirements.
Assembly on the inboard side is
recommended for freehand cutting on
account of the better balance.
Outboard mounting
Disassemble the abrasive wheel
N
(see "Fitting / replacing an abrasive
wheel")
Removing the water attachment
1
2
Unscrew the banjo bolt (1) with the
N
combination wrench – in the
process, remove the square nut
from the inside of the guard from the
guide
Remove the water hose (2) with
N
connector from the adjusting
lever (3)
Pull the water hose (2) out of the
N
guide (arrows) in the V-belt guard
Removing the adjusting lever
3
Unscrew the banjo bolt (1) with the
N
combination wrench and remove it
together with the seal – in the
process, remove the square nut
from the inside of the guard from the
guide
Unscrew the screw (2)
N
Turn the adjusting lever (3) upwards
N
and remove
Slackening the V-belt
3
1
1
1
1
Unscrew the nuts (1) – do not
N
remove them
Turn the tensioning nut (2)
N
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
English
2
1
2
0
23