Honda ANF125 2010 Manual Del Propietário página 100

Front Wheel Installation
1. Install the side collars into the left and
right side wheel hub.
2. Position the front wheel between the fork
legs and insert the front axle shaft from
the right side, through the right fork leg
and wheel hub.
When installing the wheel, carefully fit
the brake disc between the brake pads to
avoid damaging the pads.
3. Tighten the front axle nut to the specified
torque.
Front axle nut torque:
59 N·m (6.0 kgf·m , 44 lbf·ft)
4. After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not
rotate freely.
5. Install the front axle nut cap.
90
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
http://mototh.com