Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Rear Wheel Installation
To install the rear wheel, reverse the
removal procedure.
1.
Install the side collars into the left and
right side wheel hub.
2.
Tighten the rear axle nut and brake
stopper arm nut to specified torque.
Rear axle nut torque:
59 N·m (6.0 kgf·m , 44 lbf·ft)
Brake stopper arm nut torque:
22 N·m (2.2 kgf·m , 16 lbf·ft)
3.
Adjust the drive chain (pages
and rear brake pedal freeplay (page
4.
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not
rotate freely.
5. Except GR type
〈
〉
Install the chain covers and tighten the
bolts A and bolt B (page
83
84
)
−
22
).
82
).
http://mototh.com
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
A used cotter pin may not effectively secure
a fastener. Always replace a used cotter pin
with a new one.
93
Publicidad
Tabla de contenido
