Honda ANF125 2010 Manual Del Propietário página 85

1. Place a drain pan under the crankcase.
2. To drain the oil, remove the oil filler cap/
dipstick, oil drain bolt ( ), and sealing
washer ( ). 2
3. Operate the kickstarter several times to
aid in complete draining of the remaining
oil.
4. Check that the sealing washer on the
drain bolt is in good condition and install
the bolt. Replace the sealing washer
every other time the oil is changed, or
each time if necessary.
Oil drain bolt torque:
24 N·m (2.4 kgf·m , 18 lbf·ft)
5. Fill the crankcase with the recommended
grade oil; approximately:
0.7 (0.7 US qt , 0.6 Imp qt)
6. Install the oil filler cap/dipstick.
7. Start the engine and let it idle for 3 5
minutes.
8. 2 3 minutes after stopping the engine,
−
check that the oil level is at the upper
level mark on the oil filler cap/dipstick
with the motorcycle on its center stand,
level ground. Make sure there are no oil
leaks.
1
−
http://mototh.com
(1)
(1) Oil drain bolt
(2)
(2) Sealing washer
75