Engine Speed; Propeller Selection; Forward And Reverse - TOHATSU EvenRun MX 25H Manual Del Propietário

 Engine speed
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 300 rpm
for several minutes.
Clutch in (In gear)
900rpm
 Propeller selection
Propeller must be selected that will allow
the engine to reach recommended rpm
when cruising at wide-open throttle.
Model Wide-open throttle rpm range
25H 5000 - 6000 rpm
30H 5150 - 5850 rpm
Genuine propellers are listed on PROPEL-
LER TABLE of this manual.
Clutch off (Out of gear)
1050rpm
ENGINE OPERATION

3. Forward and reverse

WARNING
Before shifting into forward or reverse,
make sure that boat is properly moored
and outboard motor can be steered fully to
the right and left. Make sure that no swim-
mer(s) is ahead or astern of the boat.
WARNING
 Attach other end of emergency stop
switch tether to the operator's clothing
or arm and keep it attached during
cruising.
 Do not attach the tether to a part of
clothing that can be torn easily when
pulled.
 Arrange the tether so that will not be
caught by any object when pulled.
 Be careful not to pull the tether acciden-
tally during cruising.
Unintentional stop of engine can cause
loss of control of outboard motor. Rapid
loss of engine power can lead to falling
down or causing passenger(s) to be
thrown overboard.
Note
Do not increase engine speed unnecessarily
in reverse.
23
5