Removing And Carrying The Outboard Motor; Removing The Outboard Motor; Carrying The Outboard Motor; Storing The Outboard Motor - TOHATSU EvenRun MX 25H Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

30

REMOVING AND CARRYING THE OUTBOARD MOTOR

REMOVING AND CARRYING THE OUTBOARD MOTOR

1. Removing the outboard motor

1
Stop the engine.
2
Disconnect the fuel connector, the
remote control cables and the battery
cords from the outboard motor.
3
Remove the outboard motor from boat
and completely drain the water from the
gear case.
Engine may be hot immediately after oper-
ating and could cause burns if touched.
Allow Engine to cool down before attempt-
ing to carry the outboard.

2. Carrying the outboard motor

6
Keep the outboard motor in a vertical posi-
tion when carrying.
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak,
potentially catching fire.
CAUTION
WARNING

3. Storing the outboard motor

Outboard motor should be stored in a ver-
tical position.
Note
If the outboard motor must be laid down be
sure the tiller handle faces down as shown
in the drawing below.
Elevate power unit 2 inches to 4 inches if
traveling to avoid oil spillage.
Propeller
CAUTION
Do not carry or store outboard motor in
any of positions described below.
Otherwise, engine damage or property
damage could result from leaking oil.
Power head
Handle

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido