Getting Started
Connecting the AM and FM Antennas
AM loop antenna
(supplied)
Snap the tabs on the loop
into the slots of the base
to assemble the AM loop
antenna.
1
2
220V
230-240V
2
AM antenna connection
Connect the AM loop antenna supplied to the AM LOOP
terminals.
1
Remove the insulation if the AM loop antenna wire is
covered with vinyl.
2
Press and hold the clamp of the terminal (1), then insert
the wire (2).
3
Release the clamp.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-
covered wire (not supplied) to the AM EXT terminal. Keep
the AM loop antenna connected.
If AM reception is poor,
connect an outdoor
single vinyl-covered wire
(not supplied).
AM LOOP
AM EXT
ANTENNA
3
1
VOLTAGE
110V
SELECTOR
127V
CAUTION:
SPEAKER
IMPEDANCE
1 OR 2:
8
16
1 AND 2:
16
32
If FM reception is poor, connect
outdoor FM antenna (not supplied).
FM antenna (supplied)
FM 75
COAXIAL
CAUTION:
SPEAKER
IMPEDANCE
8
16
FM antenna connection
Connect the FM antenna supplied to the FM 75 Ω COAXIAL
terminal as temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna
(not supplied). Before attaching a 75 Ω coaxial cable with a
connector (IEC or DIN45325), disconnect the supplied FM
antenna.
Note:
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. This could cause
poor reception.
6