JVC RX-DV31SL Manual De Instrucciones página 23

To stop playback
Press 7.
The unit memorizes the point where you stop playback and
the RESUME indicator lights up on the display (except when
an audio CD is loaded).
While the RESUME indicator is lit on the display, you can start
playback from the memorized point by pressing 3—Resume
play (see "About Resume play" on page 19).
To remove the loaded disc
Press 0 on the front panel or OPEN/CLOSE on the remote
control.
The disc tray opens.
After removing the disc, press the button again to close the
disc tray
• If you press STANDBY/ON on the front panel or
AUDIO on the remote control while the disc tray is open,
the disc tray closes automatically, then the unit is turned
off.
7 Other operation buttons for the DVD player
On the front panel
From the remote control
To stop playback temporarily
Press 8.
• Pressing 3 starts playback again.
To move back the playback position by 10 seconds
(for DVD VIDEO only)
Press 3 during DVD VIDEO playback.
The unit moves the playback position about 10 seconds
before the current position, then resumes playback.
To advance or reverse playback rapidly
• Press ¡ or 1 during playback (remote control ONLY).
Each time you press ¡ (or 1), the unit advances (or
reverses) playback, rapidly changing the playback speed
as follows:
For DVD VIDEO:
x2 ] x5 ] x10 ] x20 ] x60
For DVD AUDIO/VCD/SVCD/CD:
x2 ] x5 ] x10 ] x20
Pressing 3 resumes the normal playback.
• Press and hold ¢ or 4.
While you are pressing and holding ¢ (or 4), the unit
advances (or reverses) playback 5 times as fast as the
normal speed. When you press and hold ¢ (or 4)
further, the playback speed changes up to 20 times as fast
as the normal speed.
Releasing the button resumes the normal playback.
To locate the beginning of the chapter or track
Press ¢ or 4.
Press ¢ (or 4) to locate the beginning of the next (current
or previous) chapter or track.
To locate the chapter or track using the number buttons
Press the number buttons (1 – 10, +10) to select the number
of the desired chapter or track.
Ex.: To select 3, press 3.
To select 11, press +10, then 1.
To select 20, press +10, then 10.
18