Speaker Setting Menu-Spk. Setting - JVC RX-DV31SL Manual De Instrucciones

Choice Menu Operations
7 Speaker setting menu—SPK. SETTING
SPK. SETTING
SIZE
LEVEL
DISTANCE
CROSS OVER 100Hz
RETURN TO INITIAL
¶ SIZE
Select this to enter the SIZE submenu.
SIZE
FRONT SPEAKER LARGE
CENTER SPEAKER SMALL
SMALL
SURROUND SPEAKER
SUB WOOFER NONE
RETURN
FRONT SPEAKER, CENTER SPEAKER, and
SURROUND SPEAKER
Select one of the following settings for each speaker:
LARGE Select when the size of the cone
speaker unit built in your speaker is
greater than 12 cm.
SMALL Select when the size of the cone
speaker unit built in your speaker is
smaller than 12 cm.
NONE Select when you have not connected a
speaker (not selectable for the front
speakers).
SUB WOOFER
Select one of the following settings:
USE Select when a subwoofer is connected.
NONE Select when no subwoofer is used.
RETURN
Select this to return to SPK. SETTING menu.
Notes:
• If you have selected "SMALL" for the front speakers, you cannot
select "LARGE" for the center and surround speakers.
• If you have selected "NONE" for subwoofer, you cannot select
"SMALL" for the front speakers.
• You can take advantage of the speaker diagrams on the left part of
the SPK. SETTING menu to set the speaker.
– The speaker diagram for the selected speaker is highlighted.
– The size of the speaker diagram is changed according to your
settings.
Speaker diagrams
Subwoofer
57
¶ LEVEL
Notes:
• When "NONE" is selected for the center speaker, surround
speakers, and/or subwoofer on the SIZE menu, "–" appears instead
of the current setting. In this case, you cannot adjust the output
level of those speakers.
• You can adjust the output level for center speaker and/or surround
speakers only when one of the proper Surround modes is activated
(see page 32).
• When "NONE" is selected for the center and/or surround speakers
on the SIZE menu, the test tone does not come out of those
speakers.
¶ DISTANCE
Front speakers
Notes:
• When "NONE" is selected for the center speaker and surround
speakers on the SIZE menu, "–" appears instead of the current
Center speaker setting. In this case, you cannot adjust the speaker distance of
those speakers.
• When "NONE" is selected for the center speaker and/or surround
speakers on the SIZE menu, the test tone does not come out of
those speakers.
Surround speakers
Select this to enter the LEVEL submenu.
LEVEL
CENTER SPEAKER 0dB
0dB
SURROUND LEFT SPEAKER
SURROUND RIGHT SPEAKER 0dB
SUB WOOFER –
TEST TONE
RETURN
CENTER SPEAKER, SURROUND LEFT
SPEAKER, SURROUND RIGHT SPEAKER, and
SUB WOOFER
Adjust the speaker output level within the range of –10 dB
to +10 dB for each speaker in 1 step intervals.
TEST TONE
Select this to start or stop test tone.
RETURN
Select this to return to SPK. SETTING menu.
Select this to enter the DISTANCE submenu.
DISTANCE
FRONT SPEAKER 3.0m
3.0m
CENTER SPEAKER
3.0m
SURROUND SPEAKER
TEST TONE
RETURN
FRONT SPEAKER, CENTER SPEAKER, and
SURROUND SPEAKER
For each speaker, set the distance from the listening point
within the range of 0.3 m to 9.0 m, in 0.3 m intervals.
TEST TONE
Select this to start or stop test tone.
RETURN
Select this to return to SPK. SETTING menu.