Operating Video Components - JVC RX-DV31SL Manual De Instrucciones

7 CD recorder
After pressing CDR, you can perform the following operations
on a CD player and a CD recorder:
3
Starts playing.
4
Returns to the beginning of the current (or
previous) track.
¢
Skips to the beginning of the next track.
¡
Searches forwards for a particular point.
1
Searches backwards for a particular point.
7
Stops playing.
8 Pauses playing. To release it, press 3.
1 – 10, +10 Selects a track number directly.
For track number 5, press 5.
For track number 15, press +10, then 5.
For track number 20, press +10, then 10.
For track number 30, press +10, +10, then
10.
Note:
• When you start recording on the CD recorder, use the buttons on
the CD recorder itself or on the remote control supplied with it.
7 Tuner
You can always perform the following operations:
FM/AM Tunes into the last selected FM or AM
station.
• Each time you press the button, the band alternates
between FM and AM.
After pressing FM/AM, you can perform the following
operations on a tuner:
1 – 10, +10 Selects a preset channel number directly.
For channel number 5, press 5.
For channel number 15, press +10,
then 5.
For channel number 20, press +10,
then 10.
TUNING 9 or ( Tunes in to stations.
MEMORY Memorizes preset channels.
FM MODE Changes the FM reception mode.

Operating Video Components

To operate JVC's video components using this remote
control
• You need to connect JVC's video components through the
AV COMPU LINK- jacks (see page 63) in addition to the
audio/video connections (see pages 9 to 11).
• Some JVC's VCRs can accept two types of the control
signals—remote codes "A" and "B." Before using this
remote control, make sure that the remote control code of
the connected VCR is set to code "A."
• To operate the video component(s) using the remote
control, aim the remote control directly at the remote sensor
on each component, not on this unit.
7 TV
You can always perform the following operations:
TV Turns on or off the TV.
TV VOL +/– Adjusts the volume.
TV/VIDEO Sets the input mode (either TV or VIDEO).
After pressing TV, you can perform the following operations
on a TV:
CHANNEL +/– Changes the channels.
1 – 9, 0, 100+ Selects the channels.
For channel number 5, press 5.
For channel number 10, press 1, then 0.
For channel number 23, press 2, then 3.
For channel number 135, press 100+, 3,
then 5.
TV RETURN Alternates between the previously selected
channel and the current channel.
7 VCR
You can always perform the following operations:
VCR Turns on or off the VCR.
After pressing VCR, you can perform the following operations
on a VCR:
CHANNEL +/– Changes the channels.
1 – 9, 0 Selects the TV channels on a VCR.
For channel number 5, press 5.
For channel number 10, press 1, then 0.
For channel number 23, press 2, then 3.
3
Starts playing.
1
Rewinds a tape.
¡
Fast-winds a tape.
7
Stops playing.
8 Pauses playing. To release it, press 3.
66