Getting Started
7 Digital connection
DIGITAL IN
DIGITAL 1
DIGITAL 2
(DBS)
(TV)
CAUTION:
SPEAKER
IMPEDANCE
8
16
DIGITAL OUT
PCM/STREAM
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord. When
unplugging the cord, always grasp the plug so as not to
damage the cord.
Putting Batteries in the Remote Control
Before using the remote control, put two supplied batteries
first.
1
Press and slide the battery
cover on the back of the
remote control.
2
Insert batteries. Make sure
to match the polarity: (+) to
(+) and (–) to (–).
3
Replace the cover.
11
B
A
Before connecting an
optical digital cord,
unplug the protective
plug.
B
Connect the CD recorder using the
DIGITAL OUT terminal for digital
recording.
Now, you can plug the power cord of the unit into the AC outlet.
You can connect either of
the following components
to DIGITAL IN terminals.
DIGITAL
OUT
DIGITAL
OUT
DIGITAL
IN
Notes:
• Keep the power cord away from the connecting cords and the
antenna cables. The power cord may cause noise or screen
interference.
• The preset settings such as preset channels and sound adjustment
may be erased in a few days in the following cases:
– When you unplug the power cord.
– When a power failure occurs.
If the range or effectiveness of the remote control decreases,
replace the batteries. Use two R6P(SUM-3)/AA(15F) type dry-
cell batteries.
Note:
Supplied batteries are for the initial setup. Replace for continued use.
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the
polarity: (+) to (+) and (–) to (–).
• Use the correct type of batteries. Batteries that look similar
may differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
When using the remote control,
aim the remote control directly at
the remote sensor on the unit.
TV
DBS tuner
CD recorder
CD recorder
Remote sensor