Sartorius Maxicaps MR Instrucciones De Manejo Originales página 31

6.2 Flush Filter Unit
Requirements
The filter unit is filled and vented.
CAUTION
Risk of injury due to escaping liquid!
Liquid may escape if tubes burst or if there are leaks in the connection areas.
People may be injured as a result.
Observe the maximum operating pressures (see details on the filter
t
unit).
If using an Advanced venting tubing set: Check that the tri-clamp con-
t
nections are fitted securely and retighten if necessary.
Use a measurement device for pressure monitoring.
t
Do not leave the process unsupervised.
t
Procedure
To start the flush:
t
Put the inlet valve actuator and outlet valve actuator in the [open]
t
position.
Start flow rate.
t
To end the flush:
t
Stop the flow rate.
t
Put the inlet valve actuator and outlet valve actuator in the [close]
t
position.
Operation
Maxicaps MR Operating Instructions
®
31