Publicidad
Idiomas disponibles
Idiomas disponibles
Knurled screw, left
1
Bearing plate
2
Cover plate
3
Knurled screw, right
4
1. Park the device.
2. Open the bonnet.
3. Unscrew the left-hand knurled screw.
4. Remove the bearing plate.
5. Unscrew the right-hand knurled screw.
6. Remove the cover plate.
7. Pull out the roller brush.
Installing the roller brush
Roller brush
1
Brush roller mount
2
Alignment of the bristles forwards in the direction of travel
3
1. Check roller brushes for wear and entangled pieces of tape.
2. As necessary: Install the new roller brush.
3. When installing, ensure that the bristles are correctly aligned
(roller brush mounts are identical).
4. Install the cover plate and bearing plate in reverse order.
Replacing / setting the sealing strips
Sealing strips
Setting values
Side sealing strips
Distance from floor 0 - 1 mm
Front sealing strip
Trailing distance 10-15 mm
Rear sealing strip
Trailing distance 5-10 mm
Note
The trailing distance of the front and rear sealing strip defines
how much the sealing lip folds backwards when driving the de-
vice forwards.
When set correctly, there must be a gap between the side sealing
strips and the floor.
32
Fastening
1
Side sealing strip
2
Front sealing strip
3
Rear sealing strip
4
1. Unfasten the fastening of the sealing strips.
2. Set the sealing strip by shifting it in the elongated holes.
a Refer to the table for the values.
3. Once the settings are correct, fasten the sealing strips.
Checking/replacing dust filter
DANGER
Health risk from dust
Wear a dust mark and safety goggles when working on the filter
system.
Observe the safety instructions on the handling of fine dust.
Bar cover
1
Recessed grip
2
Dust filter lever
3
Dust filter (round filter)
4
1. Park the device.
2. Wait at least 1 minute for the dust to settle.
3. Pivot the cover upwards on the recessed grip.
4. Move the dust filter lever to the right.
5. Remove the dust filter upwards.
6. As necessary: Clean the dust filter. (vacuum or carefully tap it
out) or insert a new dust filter.
Installing/removing the waste container safety brace
Installation:
1. Park the machine on a firm, horizontal surface.
2. Lower the waste container completely, see chapter Emptying
the waste container.
3. Switch off the machine, see chapter Switching off the device.
4. Open the right-hand panel, see chapter Opening/closing the
right panel.
5. Remove the safety brace.
a Pull the cotter pins out of the bolts.
English
Publicidad
