Mounting To A Pneumatic Cylinder Using A T- Or C-Slot - Balluff BMP 01-EL1PP 1A 00-P S75 Serie Manual De Instrucciones

BMP 01-EL1PP _ 1A- _ _ _ _ -00 -P _ _ /P _ _ -S4/P _ _ -S75
Magnetic Field Positioning System
4
Installation and connection (continued)
4.1 Mounting to a pneumatic cylinder using a
T- or C-Slot
For mounting to a pneumatic cylinder, slot nuts are
required (see accessories on page 30).
BMP
Cylinder
Fig. 4-1: Mounting to a pneumatic cylinder
1. Mount slot nuts on the BMP, tighten loose screws.
Fig. 4-2: Mounting T-slot nuts (left) or C-slot nuts (right
2. Align slot nuts with the straight side parallel to the slot.
Fig. 4-3: Align slot nuts (T-slot at left, C-slot at right in the image)
10 english
Target
)
3. Guide slot nuts into the slot.
Fig. 4-4: Guiding slot nuts into the slot (T-slot at left, C-slot at right in
the image)
Fig. 4-5: Slot nuts in the slot (side view; T-slot at left, C-slot at right
in the image)
4. Position the BMP.
5. Tighten screws (torque: 0.1 Nm).
0.1 Nm
Fig. 4-6: Tightening slotted screws (T-slot at left, C-slot at right in the
image)
Fig. 4-7: Slot nuts in place in the slot (side view; T-slot at left, C-slot
at right in the image)
⇒ Slot nuts are rotated 90°.
⇒ The BMP is fixed in place.
0.1 Nm