Io-Link Interface; Communication Parameters - Balluff BMP 01-EL1PP 1A 00-P S75 Serie Manual De Instrucciones

BMP 01- EL1PP _ 1A- _ _ _ _ -00 -P _ _ /P _ _ -S4/P _ _ -S75
Magnetic Field Positioning System
7

IO-Link interface

7.1

Communication parameters

In Tab. 7-1, the basic IO-Link specification for standard
variant BMP 01-... is described.
Specification
Transmission rate
Minimum cycle time of device
Frame specification:
– Amount of preoperate data required
– Amount of operate data required
– ISDU
IO-Link protocol version
Amount of process data from the device to the master
Amount of process data from the master to the device
Manufacturer ID
Device identification
IO-Link profile
IO-Link profile type
Tab. 7-1: BMP device specification
The minimum cycle time of the BMP is 1 ms.
The master can increase the cycle time as
necessary, and as a result, the cycle time
actually used (mastercycletime) depends on the
master.
www.balluff.com
IO-Link Description
COM3
MinCycleTime
M-Sequence Capability:
– M-Sequence Type Preoperate
– M-Sequence Type Operate
– ISDU supported
Revision ID
ProcessDataIn
ProcessDataOut
Vendor ID
Device ID
Profile
Profile Type
Value
230.4 kBaud
1 ms (0x0A)
0×19
2 bytes
1 Byte
Supported
0x11 (Version 1.1)
6 byte (0xC5)
0 byte (0x00)
0x0378
0x0D0101
Smart sensor profile Ed 2
(digital measuring sensor)
SSP 3.2
english 17