Analog Interface And Switching Output; Voltage Output 0; Current Output 4; Switching Output - Balluff BMP 01-EL1PP 1A 00-P S75 Serie Manual De Instrucciones

BMP 01- EL1PP _ 1A- _ _ _ _ -00 -P _ _ /P _ _ -S4/P _ _ -S75
Magnetic Field Positioning System
6

Analog interface and switching output

When IO-Link communication is active, the
analog output is disabled.
The minimum selectable measuring range is
5 mm.
6.1 Voltage Output 0...10 V
Range Teach
minimum
10.5 V
10 V
0 V
Fig. 6-1: Analog voltage output
For the adjustment process, see section 6.4 on
page 16.
6.2 Current Output 4...20 mA
Range Teach
minimum
20 mA
4 mA
3.5 mA
Fig. 6-2: Analog current output
For the adjustment process, see section 6.4 on
page 16.
www.balluff.com
Range Teach
maximum
Before
After
Target position
Range Teach
maximum
Before
After
Target position
6.3

Switching output

Switching signal (factory setting)
active
inactive
Fig. 6-3: Switching signal (factory setting)
Taught-in switching signal
(Teach 1 (switch-on point) and Teach 2 (switch-off point)
carried out)
Teach 1 Teach 2
active
inactive
Teaching in possible in the complete
configured measuring range
Fig. 6-4: Taught-in switching signal
N.O./N.C.
As standard, the switching output is configured as a
normally open contact (image above). It can be converted
to normally closed logic.
Teach 1 Teach 2
active
inactive
Teaching in possible in the complete
configured measuring range
Fig. 6-5: Taught-in switching signal
For the adjustment process, see section 6.4 on
page 16.
english 15