Analog And Switching Output; Io-Link Interface; Led Display - Balluff BMP 01-EL1PP 1A 00-P S75 Serie Manual De Instrucciones

BMP 01-EL1PP _ 1A- _ _ _ _ -00 -P _ _ /P _ _ -S4/P _ _ -S75
Magnetic Field Positioning System
3
Structure and function (continued)
3.2.1

Analog and switching output

Analog output
– Switchable between:
– 0...10 V (output value outside of the configured
measuring range: 10.5 V)
– 4...20 mA (output value outside of the configured
measuring range: 3.5 mA)
– Start and end point of the measuring range are
adjustable.
– 12-bit resolution (adjusted to the configured measuring
range)
Switching output
– Adjustable switch-on and switch-off point
– Measuring range display is a factory setting (active over
the entire measuring range)
– Normally open/normally closed (switchable)
Analog and switching output are described in Chapter 6
on page 15.
3.2.2

IO-Link interface

– Absolute measured value (μm)
– Measuring range display via status bit
– Four switching signals
– Extensive configuration options for the measured value
and switching signals
– Functions for state monitoring:
– Temperature detection
– Operating hours counter
– Boot cycle counter
The IO-Link interface is described in section 7 on
page 17.
8 english
3.3

LED display

In normal operation, three LEDs indicate the operating
state of the BMP.
Green Yellow Red
Fig. 3-2: Positions of the LEDs
LED
Color State
Green on Power OK
Inverse IO-Link communication active
flashing
Yellow off The target is located within the
configured measuring range.
on The target is located outside of the
configured measuring range.
Flashing The excess gain of the
5 Hz measurement is low.
The measured magnetic field
strength of the target is small.
Red off No error
Flashing Analog current output is open
5 Hz
Tab. 3-1: LED display
Note, tip
Sustained, asynchronous flashing of all LEDs
indicates a serious error. The BMP likely needs
to be replaced.
Operating state