Publicidad
Idiomas disponibles
Idiomas disponibles
Table of Contents
1 Safety information
on page 3
2 Startup
on page 3
3 User interface and navigation
Section 1 Safety information
Refer to the installation manual for general safety information, hazard descriptions and precautionary
labels descriptions.
Section 2 Startup
Connect the power cord to an electrical outlet with protective earth ground.
2.1 Set the power switch to on
Refer to the illustrated steps that follow.
2.2 Complete the startup wizard
1. If the startup wizard does not start automatically, push menu then select SETUP SYSTEM >
STARTUP ANALYZER.
2. Follow the instructions on the display.
• If prompted to set the channel sequence (measurement order), use the UP and DOWN arrows
to select a row, then push the LEFT or RIGHT arrow to select the channel. S1 is the first
channel measured followed by S2, S3 and S4.
Note: Do not select channels that contain the symbol "~" (e.g., 4-~SAMPLE4). Channels that contain the
symbol "~" are not measured.
• When prompted to adjust the sample flow rate for a channel, turn the sample flow valve for the
channel counter-clockwise to increase the flow rate or clockwise to decrease the flow rate.
Refer to
Figure
When the startup wizard is complete, the analyzer goes to measurement mode. The overflow
vessel fills with sample water. Bubbles (conditioning gas) are seen in the right chamber of the
measurement cell.
3. Become familiar with the keypad functions and the data shown on the measurement screen.
Refer to
User interface and navigation
4. Configure the analyzer. Refer to
on page 4
1.
on page 4.
Configuration
4 Configuration
on page 8
5 Calibration
on page 22
6 Operation
on page 25
on page 8.
English 3
Publicidad
