Publicidad
Idiomas disponibles
Idiomas disponibles
Using the appliance
Open the appliance door only briefly.
Transport purchased food in a cool bag and place in
the appliance quickly.
Let warm food and drinks cool down before placing
them in the appliance.
Place food to be defrosted in the cooling compartment
in order to utilize the low temperature of the frozen
food.
Always leave a space between the food and to the back
panel.
Pack food airtight.
Do not cover or block the ventilation openings.
Close the freezer compartment door carefully.
--------
Before using for the first time
1.
Remove information material, adhesive tape and
protective foil.
2.
Clean the appliance.
~ "Cleaning" on page 22
Electrical connection
9
CAUTION
Do not connect the appliance to electronic energy
saver plugs.
Note: You can connect the appliance to mains-controlled
and sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are connected directly to the national grid.
Sine-controlled inverters must be used for isolated
applications. Isolated applications, e.g. on ships or in
mountain lodges, are not directly connected to the
national grid.
1.
After installing the appliance, wait at least 1 hour
before connecting it to prevent damaging the
compressor.
2.
Check that the outlet was installed according to the
regulations and complies with the requirements.
The air in the appliance does not warm up as intensely.
The appliance needs to cool less frequently and there-
fore consumes less power.
The air can circulate and the humidity will remain con-
stant. The appliance needs to cool less frequently and
therefore consumes less power.
The air on the back panel of the appliance does not
warm up as intensely. The appliance consumes less
power if the warm air can escape.
The freezer compartment will become covered in thick
ice. If greater demands are made of the appliance, the
power consumption will increase.
Requirements for outlets
Outlet with
Protective
conductor
Fuse
Maximum simultaneous load
Appliance
3.
Connect the appliance to an outlet near the appliance.
The outlet must also be freely accessible following
installation of the appliance.
9
WARNING
Risk of electric shock!
Never use multiple outlets, extension cords or
adapters.
The appliance must be grounded correctly.
Never cut through or remove the power cord's
third conductor (grounding conductor).
Risk of electric shock!
If the power cord is too short, never use
multiple outlets or extension cords. Instead,
please contact customer service.
Installation and connection
110 V ... 120 V
60 Hz
10 A ... 16 A
6 A
en-us
9
Publicidad
