TensCare unifit Instrucciones De Uso página 13

between the
you wish to change. The selected
setting will flash.
Use CH2▲ ▼ to increase or decrease
3.
these settings.
4. To confirm your manual settings,
press the settings button again.
Alternativelty,
automatically confirm your settings
if no button is pressed for 5 seconds.
Warning: In
programmes a warning triangle
will be displayed if the Rest period is less
than Rest
Time*(WorkHz-16.66)/16.66 seconds
Programme settings can be reset by
pressing the mode and programme
buttons simultaneously.
Completing a Session
Once you have correctly connected the
device, electrode pads, selected the
mode, programme and intensity, the
treatment session will be underway.
Note: If the sensation becomes
uncomfortable,
intensity
The session will run for the selected
treatment time.
After Your Session
Should you wish to start a new session
select mode, programme and intensity
as before.
To turn the Unifit off at any stage, press
different settings
the device will
the EMS manual
Time=Work
reduce the
and hold the power button for 3 - 5
seconds.
After the session is complete and Unifit is
switched off, remove the electrode pads
from your skin by holding the electrode
pad itself and gently pulling. Do not pull
on the lead wires or the pigtail wire of the
electrode pad.
Replace the electrode pads to their
protective plastic shield and return them
to the re-sealable plastic bag. Ensure the
bag is sealed.
Usage Memory
To view the usage memory, press and
hold the settings and phase skip buttons
for 3 seconds.
To return to the home screen, press and
hold the settings and phase skp buttons
for 1 second.
The device memory can be reset by
holding the mode and programme
buttons simultaenously for 3 seconds.
This can only be done whilst viewing the
memory screen.
13