Publicidad
Idiomas disponibles
Idiomas disponibles
electrode pads on the plastic liner
and inside the re-sealable plastic
bag.
•
If the electrode pads dry out,
it
is
recommended
replacement pack. It is possible to
restore some of the adhesion of
the pad by adding a tiny drop of
water on each pad and spreading
around. If too much water is added,
the electrode pad will become
too soft. If that happens, place
the electrodes sticky side up in a
refrigerator for a few hours. This
should help restore some adhesion.
•
In very hot weather the gel on the
electrode pads may become soft.
In such cases place them, still on
their plastic liners and in their re-
sealable bag, into a fridge until they
return to their normal condition.
•
The electrode pads provided are
latex-free.
•
Replace the electrode pads when
they lose their stickiness. Poor
connection may cause discomfort
and skin irritation.
•
The electrode pads must always be
used in pairs (two electrode pads
on each channel), so that the signal
can flow in a circuit.
•
You may feel more sensation in one
pad than the other. This is normal –
it depends on where the electrode
pads are in relation to your nerves.
11. Charging Unifit
Unifit
rechargeable Li-ion battery. The battery
to
buy
a
should last at least 10 hours at 50mA,
300μs, 50Hz in TENS mode.
A charging adapter is included in the kit.
It will take approximately 2 hours to fully
charge the battery.
The battery status can be seen in the
top right corner of the display. When the
remaining battery life is below 20%, the
battery icon will flash. Please charge your
Unifit device at this stage.
chargers could be hazardous and will
negate the warranty.
To charge the battery:
Connect the charger to the unit and plug
it into a mains socket. A charging screen
will be displayed, showing the battery
percentage level. Charge the device until
the battery level is 100%.
months to ensure the battery life is
maintained.
•
•
is
powered
by
Warning: Only use the charging
adapter supplied. Use of other
Note:
The
device
charged at least once every 3
Note: The device cannot be used
while being charged.
Note: Charging voltage: DC 5V,
charging current: 90mA.
Note:
Charging
specifications:
Output: DC 5 V; 1A
Rated
input
voltage
a
built-in
should
be
adapter
shall
not
23
Publicidad
