Preparations For Security Lock; Mounting - Fronius XCharge_professional Manual De Instrucciones

Preparations for
security lock

Mounting

The space requirement dimensions illustrated below in mm are given to ensure easy ac-
cess to the plug connections:
Space requirements with edge protector
+
-
NOTE! If the charger is installed in a switch cabinet (or a similar sealed area),
then forced-air ventilation must be provided to ensure adequate heat dissipation.
The charger must have an all-round clearance of 10 cm.
270
The security lock is not contained in the
scope of supply.
A security lock can only be attached
- to the groove on the housing as shown
- to the groove on the housing that is ex-
actly opposite
- using spacer M8 DIN 125 or DIN 134,
located as shown
The supplied Velcro strap is used during
charging to secure the charging lead to the
motorcycle.
100
15,5
57