Removing And Carrying The Outboard Motor; Removing The Outboard Motor; Carrying The Outboard Motor - TOHATSU MFS2.5B Manual Del Propietário

REMOVING AND CARRYING THE OUTBOARD MOTOR

ENOM00070-B

1. Removing the outboard motor

ENOW00064-0
CAUTION
Engine may be hot immediately after oper-
ating and could cause burns if touched.
Allow engine to cool down before attempt-
ing to carry the outboard.
1. Stop the engine.
2. Remove the top cowl.
3. Disconnect the fuel connector, the
remote control cables and the battery
cords from the outboard motor.
4. Remove the outboard motor from boat
and completely drain the water from
the gear case.
ENOM00071-A

2. Carrying the outboard motor

ENOW00933-0
WARNING
Be sure to disconnect fuel connector
except when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00065-0
Close air vent screw of fuel tank before
carrying or storing outboard motor and fuel
tank, or fuel may leak, potentially catching
fire.
ENOW00066-0
Do not give a shock to an outboard
motor during transportation. It becames
a cause of breakage.
Do not carry or store outboard motor in
any of positions described below.
Otherwise, engine damage or property
damage could result from leaking oil.
Keep the outboard motor in a vertical posi-
tion when carrying.
ENOF01607-0
The optional outboard motor stand is rec-
ommended for keeping the outboard
motor vertical both during transport and
storage.
WARNING
CAUTION
ENOF01613-0
35
8