Removing And Carrying The Outboard Motor; Removing The Outboard Motor; Carrying The Outboard Motor - TOHATSU MFS 9.9E Serie Manual Del Propietário

REMOVING AND CARRYING THE OUTBOARD MOTOR

ENOM00070-A

1. Removing the outboard motor

ENOW00890-0
WARNING
Before installing the outboard motor on the
boat, hang the outboard motor with the
hoist or equivalent device by attaching the
engine hanger to the outboard.
Use the hoist with allowable load is 150 kg
(330 lbs) or above.
ENOW00064-0
CAUTION
Engine may be hot immediately after oper-
ating and could cause burns if touched.
Allow engine to cool down before attempt-
ing to carry the outboard.
1. Stop the engine.
2. Remove the top cowl.
3. Disconnect the fuel connector, the
remote control cables and the battery
cords from the outboard motor.
4. Attach the hoist hooks to the engine
hanger.
5. Remove the outboard motor from boat
and completely drain the water from
the gear case.
All manuals and user guides at all-guides.com
ENOM00071-A

2. Carrying the outboard motor

ENOW00933-0
Be sure to disconnect fuel connector
except when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00065-0
Close air vent screw of fuel tank before
carrying or storing outboard motor and fuel
tank, or fuel may leak, potentially catching
fire.
ENOW00066-0
WARNING
WARNING
CAUTION
Do not give a shock to an outboard
motor during transportation. It becames
a cause of breakage.
49
ENOF01206-1
8