Removing And Carrying The Outboard Motor; Removing The Outboard Motor; Carrying The Outboard Motor - TOHATSU MFS 5C LPG Manual Del Propietário

REMOVING AND CARRYING THE OUTBOARD MOTOR

ENOM00070-D
1. Removing the outboard
motor
ENOW00064-0
CAUTION
Engine may be hot immediately after operat-
ing and could cause burns if touched. Allow
engine to cool down before attempting to
carry the outboard.
1
1. Cooling water check port
1. Before stopping the engine, close the
valve of the propane tank to consume
remained fuel in the fuel line. And
wait until engine is stopped.
2. Disconnect the fuel connector, the
remote control cables and the bat-
tery cords from the outboard motor.
3. Remove the outboard motor from
boat and completely drain the water
from the gear case.
ENOM00071-A

2. Carrying the outboard motor

ENOW00933-0
Be sure to disconnect fuel connector except
when operating engine.
ENOF00437-1
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00952-0
When transporting, keep tank secured in
an upright position with the tank valve
turned off.
Do not use, store or transport tank where
it would be exposed to high tempera-
tures.
ENOW00066-0
Do not give a shock to an outboard motor
during transportation. It becames a cause
of breakage.
Do not carry or store outboard motor in
any of positions described below.
Otherwise, engine damage or property
damage could result from leaking oil.
ENOF01505-0
WARNING
WARNING
CAUTION
39
8