56
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENOM00070-A
1. Removing the outboard
motor
ENOW00890-0
Before installing the outboard motor on the
boat, hang the outboard motor with the
hoist or equivalent device by attaching the
engine hanger to the outboard.
Use the hoist with allowable load is 250 kg
(550 lbs) or above.
ENOW00064-0
Engine may be hot immediately after operat-
ing and could cause burns if touched. Allow
engine to cool down before attempting to
carry the outboard.
1. Stop the engine.
2. Remove the top cowl.
8
3. Disconnect the fuel connector, the
remote control cables and the bat-
tery cords from the outboard motor.
4. Attach the hoist hooks to the engine
hanger.
5. Remove the outboard motor from
boat and completely drain the water
from the gear case.
WARNING
CAUTION
ENOM00071-A
2. Carrying the outboard motor
ENOW00933-0
WARNING
Be sure to disconnect fuel connector except
when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00065-0
WARNING
Close air vent screw of fuel tank before car-
rying or storing outboard motor and fuel
tank, or fuel may leak, potentially catching
fire.
ENOW00066-0
CAUTION
Do not give a shock to an outboard motor
during transportation. It becames a cause
of breakage.
ENOF00840-0