VM Motori R756EU6C Manual De Instrucciones página 113

AIR FILTER CLEANING AND REPLACEMENT
The air filter is equipped with a clogging
indicator (A) that gradually switches from
GB
white (clean filter) to red (clogged filter).
When the indicator is red, follow the
procedure below to replace the filter:
1 - Unscrew the fastening screw (B),
disassemble the cyclone pre-filter (C) and
clean it with low pressure compressed air
(lower than 5 bar).
2 - Open the closing hooks (D) and
disassemble the cover (E).
3 - Remove the "main" filter cartridge (F),
and clean it with a low pressure air jet
(lower than 5 bar) aimed outwards.
4 - Check the wear condition of the "main"
filter cartridge (F) and, if necessary,
replace it, or contact the manufacturer of
the vehicle in which the engine is installed
or a workshop authorised by VM MOTORI
FCA ITALY.
5 - Clean the air filter housing with a
clean, lint-free cloth dampened with non-
aggressive detergent.
Cover (E)
Main filter cartridge (F)
Closing hook (D)
Cyclone pre-filter (C)
Screw (B)
English
6 - Replace the filter safety cartridge
(G) if damaged. In any case, replace
the cartridge (G) after 5 (five) cleaning
operations on the main filter cartridge
(F), or contact the manufacturer of the
vehicle in which the engine is installed or a
workshop authorised by VM MOTORI FCA
ITALY.
7 - Refit the main filter cartridge (F), the
cover (E) and the cyclone pre-filter (C).
8 - At the end of the operation, press the
button of the clogging indicator (A) towards
the filter body to reset its colour.
When cleaning the air filter, pay
attention that no solid or liquid
substances enter the engine intake
duct.
Filter safety cartridge (G)
Clogging indicator (A)
50
R756EU6C
42432100F