VM Motori R756EU6C Manual De Instrucciones página 116

ENGINE OIL FILTER CARTRIDGE REPLACEMENT
Follow the procedure below.
1 - Carry out the operation with the engine
off and warm or cold.
2 - Ignition key removed.
3 - Prepare a container under the filter to
collect any leak.
4 - Unscrew the cartridge with suitable
standard wrench and replace it. Clean the
surface of the support in contact with the
oil cartridge with a clean, lint-free cloth.
5 - Lubricate the seal of the new cartridge
before assembling it.
6 - Assemble the new oil cartridge and
manually tighten it until it locks.
Check the oil cartridge tightening
using a torque wrench calibrated at
12.7 Nm.
7 - Turn the engine on and keep it running
at idle speed for approx. five minutes at
a temperature of 70°C - 80°C (158°F -
176°F).
8 - Turn off the engine and remove the
ignition key.
9 - Wait for a few minutes so that all the
oil flows into the sump.
10 - Check the correct oil level and, if
necessary, top it up (see "Engine oil level
check" on page 51).
11 - Start the engine, leave it at idle
speed and with no applied loads, check
for any oil leaks and the oil pressure (see
technical data table on page 14).
12 - Turn off the engine at the end of the
check.
English
Seal
Oil Filter
In case of oil leaks and/or non-
compliant oil pressure values (see
technical data table on page 14),
immediately stop the engine and
contact the manufacturer of the vehicle
in which the engine is installed or a
workshop authorised by VM MOTORI
FCA ITALY.
Do not dump any polluting material
in the environment. Carry out their
disposal in compliance with the
relevant legislation in force.
53
R756EU6C
GB
42432100F