VM Motori R756EU6C Manual De Instrucciones página 114

ENGINE OIL LEVEL CHECK
Turn off the engine and remove the
ignition key. Turn on the engine after
at least five minutes from turning off,
paying attention not to touch the en-
gine parts to avoid the risk of burning.
To check the engine oil level, follow the
procedure below:
1 - Position the vehicle so that the engine
is horizontally parallel to the plane.
2 - Clean the area surrounding the oil
dipstick (L) and the filler plug (M).
3 - Remove the oil dipstick (L) clean it
with a clean, lint-free cloth and refit it fully
home.
4 - Remove the oil dipstick (L) again and
check that the oil level is between the
"MIN" and "MAX" notches.
5 - To top up, unscrew the filler plug (M),
clean the area surrounding the filler hole
and pour engine oil up to and not beyond
the "MAX" notch.
6 - Refit the oil dipstick (L) and close the
filler plug.
LUBRICANTS
The lubricant recommended by VM
MOTORI FCA ITALY is: Q8 T 905 10W-
40 for operating temperatures from -10°C
(14°F) to +50°C (122°F).
English
Oil Dipstick (L)
For a correct engine filling oil quantity,
refer to the values in section "Technical
Data" on page 14.
When topping up the oil, to avoid
exceeding the maximum allowed value,
add the oil in small quantities (e.g.
100-200 ml at a time) until it reaches the
correct level.
When the engine is running, the oil level
must be between the minimum and
maximum notches.
Do not mix oils with different
characteristics. Use only oils compliant
with the specifications below (section
"Lubricants").
Oils of different brands can also be used,
provided that they have the following
characteristics:
– Grade: SAE 10W-40
– Specifications: ACEA E6, E9
51
R756EU6C
Filler plug (M)
GB
42432100F