Publicidad
Idiomas disponibles
Idiomas disponibles
FUEL SUPPLY CIRCUIT BLEEDING
This operation must be carried
GB
out after each fuel filter cartridge
replacement.
Follow the procedure below.
1 - Carry out the operation with the
engine off and cold.
2 - Ignition key removed
3 - Prepare a container with appropriate
capacity under the fuel filter.
4 - Partially loosen the screw (E) to allow
the fuel to be bled to drain.
5 - Manually activate the pump (F) until
the fuel drained has no air bubbles.
6 - Tighten the screw (E).
Thoroughly dry the fuel residues
before starting the engine.
Do not use the starter motor to try to
bleed air from fuel circuit.
English
Pump (F)
Bleed
screw (E)
Do not loosen high-pressure pipe
unions of the supply circuit (common
rail system).
56
R756EU6C
42432100F
Publicidad
