7.
Adapter GB628R (AO large
to DHS/DCS)
Fig. 5
7.1
Operating principle
The adapter couples a tool to the DHS/DCS shaft and
enables an Acculan 3Ti motor to be connected
7.2
Safe operation
Note
The adapter is only suitable for use with Synthes tools
with DHS/DCS tool coupling or tools of a comparable
geometry!
►
For information on how to connect the drill and
reamer attachments, see Chapter 11.1.2.
7.2.1 Coupling the adapter
►
For coupling the adapter, see Chapter 4.2.1.
7.2.2 Uncoupling the adapter
►
For uncoupling the adapter, see Chapter 4.2.2.
7.2.3 Coupling a tool
►
Slide back unlocking sleeve 6.1.
►
Insert the tool shaft in its correct position down to
the stop in the tool coupling of the adapter.
►
Release unlocking sleeve 6.1.
The tool is now coupled.
7.2.4 Uncoupling the tool
►
Slide back unlocking sleeve 6.1.
►
Remove the tool.
10
7.3
Accessories
Designation
DHS Tripple Reamer
DHS Reamer
DHS Drill Bit
7.4
Technical Data
Dimensions L x W x H, in
mm
Weight, in grams
Drive speed, in 1/min
8.
Adapter GB176R (Zimmer
chuck with Hudson-Zimmer
coupling)
Fig. 6
8.1
Operating principle
The adapter couples a tool to the Zimmer tool shaft and
enables an Acculan 3Ti motor to be connected.
Note
The adapter is only suitable for use with drill/reamer
attachments with a series number of "SN 500" and
above!
Synthes Art. no.
338.130, 338.430
357.044, 357.045
357.047, 351.270,
359.081, 359.079
GB628R
61 x 22 x 22
approx. 70
max. 250