Publicidad
Idiomas disponibles
Idiomas disponibles
Enjoy Your Food!
STEP #5 Enjoy!
When the food is ready to be removed from the smoker, open the door, and carefully remove the food
using the appropriate protection, such as oven mitts.
The wire racks may be removed completely from the chamber to allow easy removal of the food.
Stopping the Smoker
At any time during operation, the smoker may be stopped by pressing the [Cancel] or power
button.
If the appliance was Smoking, the smoking chamber will clear the smoke first. The smoker will return to
the standby mode.
Shutting Off the Smoker
After 30 minutes of inactivity during standby, the display will
automatically turn off and the smoker will go to sleep.
To manually shut off the smoker, press the power
button.
NOTE: If the appliance was recently generating smoke, the Active
Smoke Filtering system may continue to operate in the background for
up to 10 minutes. This is to ensure the smoke has been properly cleared
from the chamber before fully shutting off the appliance. During this
time, the words "SMOKE CLEARING" will appear on the display. The fan
and rear heating system will continue to function until the smoke clearing process is completed.
Waking Up the Smoker
To wake up the appliance, press any button on the control panel or rotate the dial. The display will
illuminate.
Smoker Settings Menu
Auto Warm
This setting is used to toggle the AUTO WARM feature.
To disable the AUTO WARM feature, press the [Settings] button and then press the dial to select the
"AUTO WARM" option. Rotate the dial until "TURN OFF" is displayed. Then press the dial to confirm. The
AUTO WARM feature will be disabled and the words "Auto Warm On" will no longer be illuminated on the
display.
To enable the AUTO WARM feature, follow the same steps above except select the "TURN ON" setting.
To edit the temperature of the AUTO WARM feature, follow the same steps above except select the "EDIT
TEMP" setting. Rotate the dial to adjust the smoker temperature and press the dial to confirm. The setting
is now saved and will return to Settings menu.
Pellet
This setting is used to empty the pellet hopper when switching out pellet type.
To empty the pellet hopper, first ensure that the waste bin is empty and completely dry. Then open the
hopper door to observe the pellet level in the hopper.
Press the [Settings] button and rotate the dial to navigate to the "PELLETS" option. Press the dial to select.
Then press the dial again to begin the hopper emptying process. The display will show "EMPTYING
PELLETS – CANCEL TO STOP" and the auger will operate up to 20 minutes to eject the pellets in the
hopper into the waste bin.
When the hopper is empty, press the dial once again to stop the auger.
22
49-9000057 Rev. 1
Publicidad
