Angelo Po 0S0FR3E Manual De Uso página 148

ENGLISH
ELECTRICAL CONNECTION (0S0FR3E - 0S1FR4E)
WARNING: The connection must be
made by authorised, skilled personnel, in
accordance with the applicable legal re-
quirements, using appropriate and speci-
fi ed materials. The appliance is supplied
with operating voltage of 400V/3N, which
can be switched to 230V3~ (see next sec-
tion).
HAZARD: Before doing any work, turn
off the general power supply.
Connect the appliance to the mains power sup-
ply as follows:
If not already in place, install an automatic
1)
switch-disconnector (A) close to the appli-
ance with thermal magnetic circuit breaker
and residual-current circuit breaker.
10
Pull off the knobs (B).
2)
Undo the screws (C) to remove the control
3)
panel (D).
Connect the switch-connector (A) to the ter-
4)
minal board (E) of the appliance as shown in
the fi gure and in the wiring diagram at the
end of the manual. Use a fl exible cable with at
least type H07RN-F characteristics and operat-
ing temperature of at least 80°C.
tention to the neutral and earth cable con-
nection.
After completing the operation, fi t everything
5)
back in place.
B
A
WARNING: When connecting, pay at-
C
C
D
E
3413910_inst_GB_rev.1
FAULTS