Basic Operations; Turning On The Power (Standby); Turning Off The Power (Standby) - Pioneer PDP-5050HD Manual De Instrucciones

07

Basic Operations

Turning on the power (Standby)

1
Press POWER on the Plasma Display if the STANDBY
indicator is off.
• The STANDBY indicator on the Plasma Display lights
up red.
2
Confirm that the STANDBY indicators light up red, and
then press TV on the remote control unit or
STANDBY/ON on the Plasma Display or POWER on the
Media Receiver to turn the system on.
• The POWER ON indicators on the Plasma Display and
Media Receiver light up green.
• In this manual, "system" means the Plasma Display Panel and Media
Receiver.

Turning off the power (Standby)

1
Press TV on the remote control unit or STANDBY/ON
on the Plasma Display or POWER on the Media Receiver.
• The system enters the standby mode and the image on
the screen disappears.
• Both STANDBY indicators light up red.
• It is recommended to place the system into the standby
mode by pressing TV
This allows the system to automatically receive digital
TV program information in the standby mode.
• If you are not going to use this system for a long period of time, press
POWER on the Plasma Display and remove the power cord from the
power outlet.
Plasma Display/Media Receiver status indicators
Indicator Status
Plasma Display
POWER ON STANDBY
Flashing
For other than the above, see "Troubleshooting" on page 69.
24
En
on the remote control unit.
Media Receiver
POWER ON STANDBY
Flashing
Plasma Display
POWER ON indicator
POWER button
Illustration shows PDP-5045HD/4345HD.
(right view)
STANDBY/
ON button
Media Receiver
POWER
REC DATA
ON STANDBY
TIMER ACQUISITION
POWER ON indicator
POWER button
System Status
Power to the Plasma Display and Media Receiver is off. Or the power cords
have been disconnected.
Power to the system is on.
The system is in the standby mode.
The power cord has been disconnected from the Media Receiver.
Power to the Plasma Display is off. Or the power cord has been disconnected
from the Plasma Display.
STANDBY indicator
STANDBY indicator