Publicidad
Idiomas disponibles
Idiomas disponibles
Prepare the Gas Supply
1. Open the hood completely. Do not light burners with the hood
closed.
2. Make sure control knobs are turned to OFE The drip tray
must be in place and pushed all the way to the back.
A
Manually
Lighting the Main Grill
1. Do not lean over the grill.
2. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
A. Drip tray
Turn the Gas Supply On
1. For outdoor grills using a 20 Ib LP gas fuel tank:
Slowly open the tank valve.
NOTE: If flow limiting device activates, your grill may not
light. If your grill does light, the flames will be low and will not
heat properly. Turn tank valve and all control knobs off and
wait 30 seconds. After shutting off the tank, very slowly open
tank valve and wait 5 seconds before lighting.
2. For outdoor grills using gas supply source other than 20 Ib LP
gas fuel tank:
Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
3. Strike the match to light it.
4. Guide the lit match under the grill grate.
5=
Push in and turn the burner knob to IGNITE/HI for the burner
closest to the lit match. The burner will light immediately.
When burner is lit, turn knob to desired setting.
A. Closed valve
B. Open valve
Lighting the Main Grill
IMPORTANT:
If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.
1. Do not lean over the grill.
2. Select the burner you want to light. Push in and turn the grill
burner control knob to IGNITE/HI, while continuing to hold
it in.
O
6. Repeat steps 2 through 5 for each main burner.
7. Remove match and replace manual lighting extension on the
right side panel.
IM PO RTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting
to light them manually,
contact the Customer Service Center. See the "Assistance"
section.
//
,<!}'
O
3. You will hear the "snapping" sound of the spark. When burner
is lit, release the knob. Turn knob to desired setting.
4. Repeat for each of the other burners as needed.
18
Publicidad
