Metabo HPT CD 1805DB Manual página 13

○ Overload protection
This protection feature cuts off the power to the motor in the event of overloading of motor or a conspicuous
reduction in rotational speed during operation.
When the overload protection feature has been activated, the motor may stop.
In this case, release the tool switch and eliminate causes of overloading.
After that you can use it again.
○ Overheat protection
This protection feature cuts off the power to the motor and stops the power tool in the event of overheating of motor
during operation.
When the overheat protection feature has been activated, the motor may stop.
In this case, release the tool switch and cool it down in a few minutes.
After that you can use it again.
○ Rotation speed changeover function (Power mode / Silent mode)
(Power mode / Silent mode switch function)
Each press of the Mode Selector Switch changes the operating mode.
Silent mode reduces maximum motor RPM enabling efficient work with less noise.
The Silent Mode Indicator Lamp lights in Silent mode.
When the load increases during Silent mode, the tool will automatically switch to Power mode and revert back to
Silent mode when the load decreases.
In Power mode, no change is made to Silent mode even when the load decreases.
CAUTION
Do not give a strong shock to the switch panel or break it. It may lead to a trouble.
NOTE
To enable mode changes, pull the switch once after installing the battery.
Mode selector switch
Silent mode indicator lamp
Fig. 9
English
13