Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
If the cutting depth lever is loose, injury can
result. Tighten it securely after adjustment.
To adjust cutting depth, loosen the cutting depth lever
and, while holding the base with one hand, move the main
body up and down to obtain the prescribed cutting depth.
After adjusting to the prescribed cutting depth, tighten the
cutting depth lever securely.
2. Regulating the guide (Rip fence)
..................................................... Optional Accessory
Install the wing bolt and lock spring on the base. Insert the
guide into the base, move it left and right and adjust the
cutting position. Tighten the wing bolt and fix the guide.
The guide can be installed either from the left or the right
side of the main body.
Wing Bolt
Lock Spring
Base
Guide
(Rip Fence)
OPERATION
WARNING
● Never touch the moving parts.
● Never operate the power tool with the saw blade
turned upward or to the side.
● Do not fix and secure the lock-off button.
Besides, keep your finger off the trigger switch
when the power tool is being carried around.
Otherwise, the main body switch can be
inadvertently turned ON, resulting in unexpected
accidents.
Fig. 21
Wing Bolt
Base
Fig. 22
● Do not use any saw blades which do not conform
to the specified rating.
● The saw blade must be suitable for the no-load
speed.
● Use a saw blade that is suitable for the material
being sawn.
● Use only genuine metabo HPT saw blades.
● Do not use any abrasive wheels.
● Use only blade diameter specified on the product
nameplate.
● Should the saw blade be stopped or make an
abnormal noise during operation, turn off the
switch immediately.
● Always wear eye protection with side shields
that meets the requirements of ANSI Standard
Z87.1.
CAUTION
● Use this product only for cutting metal.
● Cannot be used for cutting tempered steel
materials.
● To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
● Take care not to lock the motor. If the motor is
locked, immediately turn the power off. If the
motor is locked for a while, the motor or battery
may be burnt.
1. Check if saw blade is tightened
While the saw blade is tightened securely for
immediate use when it is assembled at the factory, be
sure to check it out again for caution's sake. A bolt
can be tightened when it is turned clockwise. Use the
provided hex. bar wrench 5 mm to check it out.
Please refer to "3. Changing saw blades" in [PRIOR
TO OPERATION] for details.
2. Check if the lever is tightened (Fig. 20)
If the cutting depth lever is loose, injury can result.
Make sure that it is tightened securely.
3. Check performance of lower guard
Please refer to "4. Check performance of lower guard"
in [PRIOR TO OPERATION] for details.
English
19
Publicidad
