Publicidad
Idiomas disponibles
Idiomas disponibles
English
Lighting mode switch
Switch panel
LED Light
Table 7: States of the LED light modes
Always ON
(turn off after 2 minutes)
Light only SW-ON
(Automatically goes out
approximately 10 seconds after
the switch is released)
Always OFF
CAUTION
Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
NOTE
○ To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.
○ While the switch is pulled, the remaining battery
power is displayed (in red).
○ The mode will only change after a battery is installed
and the switch is pulled once.
○ Wipe off any dirt or grime attached to the lens of the
LED light with a soft cloth, being careful not to scratch
the lens.
Scratches on the lens of the LED light can result in
decreased brightness.
11. LED light warning signals
This product features functions that are designed to
protect the tool itself as well as the battery. If any of
the safeguard functions are triggered during
22
Lighting mode
Indicator lamp
(green)
Fig. 27
operation, the LED light will blink as described in
Table 8. When any of the safeguard functions are
triggered, immediately remove your finger from the
switch and follow the instructions described under
corrective action.
LED Light Display
On 0.1 second/
off 0.1 second
On 0.5 second/
off 0.5 second
12. Cutting procedures
WARNING
● Recheck that the saw blade is securely clamped.
● After adjusting the cutting depth, make sure that
the cutting depth lever is tightened.
● Don't remove the power tool from workpiece
during a cut while the saw blade is moving.
(1) Place the base on the material, then align the
premarked line and the saw blade with the guide slit
at the front of the base.
(2) Ensure that the switch is turned to the ON position
before the saw blade comes in contact with the steel
materials. The switch is turned ON when the trigger
switch is squeezed; and OFF when the trigger switch
is released. Moving the saw straight at a constant
speed will produce optimum cutting.
WARNING
● To avoid abnormal kickback or damage to the
saw blade, do not twist or apply excessive force
to the saw blade when cutting. Let the blade
move forward smoothly.
Table 8
Safeguard Function
Overload protection
Remove the cause of the
overburdening.
Overheat protection
Allow the tool and battery
to thoroughly cool.
Primarked line
Guide slit
Base
Fig. 28
Publicidad
