Publicidad
Idiomas disponibles
Idiomas disponibles
English
NOTE
○ Before installing the saw blade, thoroughly remove
any sawdust which has accumulated on the spindle,
hexagonal flange bolt, and washers.
○ For mounting saw blade, the concave sides of both
washers (A) and (B) must be fitted to the saw blade
sides.
Washer (B)
Hexagonal
Flange Bolt
(4) If washer (A) was removed, install it on the main unit
first. Next, mount the saw blade on the spindle, and
finally, affix washer (B).
(5) To assure proper rotation direction of the saw blade,
the arrow direction on the saw blade must coincide
with the arrow direction on the saw cover.
(6) Using the fingers, tighten the hexagonal bolt retaining
the saw blade as much as possible. Then depress the
lock lever, lock the spindle, and thoroughly tighten the
hexagonal flange bolt.
(7) Confirm that the lock lever is in the original position.
(8) Attach the dust box. (Fig. 15)
CAUTION
After mounting the saw blade, reconfirm that the
lock lever has returned to its original position.
4. Check performance of lower guard
WARNING
Make absolutely sure that the lower guard is not
fixed. Also, check and see if it can move
smoothly. If the saw blade is kept exposed,
injury can result.
The lower guard (refer to Fig. 6) serves to protect your
body from coming into contact with the saw blade. Make
absolutely certain that the cover smoothly performs to
cover the saw blade. If the lower guard should not move
smoothly, never use it without repairing it.
18
Saw Blade
Washer (A)
Fig. 18
In such a case, get in touch with the store where you
bought the power tool or the metabo HPT AUTHORIZED
SERVICE CENTER for necessary repair.
5. Check for proper operation of the brake
This power tool features an electric brake that
functions when the switch is released. Before use,
ensure that the electric brake functions properly.
If it does not, bring the tool to a metabo HPT
AUTHORIZED SERVICE CENTER.
6. Prepare a work bench
Since the saw blade will extend beyond the lower
surface of the steel materials, place the steel
materials on a work bench when cutting. If a square
block is utilized as a work bench, select level ground
to ensure it is properly stabilized. An unstable work
bench will result in hazardous operation.
Steel materials
Work bench
CAUTION
To avoid possible accident, always ensure that
the portion of steel materials remaining after
cutting is securely anchored or held in position.
ADJUSTSING THE SAW PRIOR TO USE
WARNING
To avoid serious accidents, ensure the switch is
in the OFF position, and pull out the battery.
1. Adjusting the cutting depth
Loosen
Tighten
Cutting
depth lever
Base
Base
Saw blade
Fig. 19
Fig. 20
Publicidad
