Publicidad
Idiomas disponibles
Idiomas disponibles
● When finished with a job, pull out the battery
from the main body.
CAUTION
In the situation where the power tool is
continuously operated while replacing the
battery with stocked spare batteries one after
another, the motor tends to overheat. Therefore,
whenever the housing becomes hot, give the
power tool a break for a while.
NOTE
○ Before starting to saw, ensure that the saw blade has
reached full speed revolution.
○ Avoid cutting operation in a state where the base
bottom is afloat from the material being cut.
Otherwise, the motor can get locked.
○ Do not press the lock lever while the motor is running,
as it will lock the spindle in place.
○ Do not perform continuous cutting of steel.
The heat from the chips may deform the dust box.
○ When cutting sheet metal, be sure to allow at least
20 mm of width on the cut-off side. If there is less than
20 mm, the cut-off material may get caught in the dust
box and clog it.
DISPOSING OF CHIPS
WARNING
When disposing chips, make sure that the tool is
switched off and that the battery is removed.
CAUTION
Dispose of the chips that are in the dust box
before they accumulate above the marks. Failure
to do so will reduce the efficiency of the dust
collecting. Additionally, the heat of the chips may
deform the dust box.
Marks
Fig. 29
NOTE
○ Immediately after cutting steel materials, the chips
and the dust box may be hot. Do not touch them
directly.
○ When disposing of the chips, do not allow the chips to
enter the motor portion of the tool body or the battery
mount.
○ Before changing the material to cut, dispose of the
chips that are in the dust box.
(1) Press the hook on the bottom of the dust cover, open
the dust cover, and dispose of the chips that are in
the dust box.
(2) Close the dust cover, and fasten the hook.
Dust cover
2
Hook
1
English
Fig. 30
23
Publicidad
