Publicidad
Idiomas disponibles
Idiomas disponibles
MODIFICATIONS:
metabo HPT Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without prior
notice.
WARNING
● To avoid injury from an accidental start, turn the switch OFF and pull out the battery from the power
source or remove the battery from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualified service technicians. Contact
metabo HPT Authorized Service Center.
Problem
Tool doesn't run
Tool suddenly stopped
Doesn't cut well
Switch can't be pulled
Sawdust discharge is poor
TROUBLESHOOTING GUIDE
Possible Cause
No remaining battery power
Battery isn't fully installed.
Tool was overburdened
Overload protection is in operation.
The battery or power tool has become
overheated.
The saw blade is worn or missing
teeth.
The hexagonal flange bolt is loose.
The saw blade is installed backwards. Install the saw blade in the proper
The lock-off button is not pushed in
enough.
Sawdust has accumulated in the dust
box.
Important notice on the batteries for the
metabo HPT cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used with
batteries other than these designated by us, or when the
battery is disassembled and modified (such as
disassembly and replacement of cells or other internal
parts).
Charge the battery.
Push the battery in until you hear a
click.
Get rid of the problem causing the
overburden.
Let the battery or power tool cool
down.
Replace with a new saw blade.
Firmly tighten the hexagonal flange
bolt.
direction.
Push the lock-off button in all the way.
Remove the sawdust inside the dust
box.
English
Possible Solution
25
Publicidad
