Using The Automatic Wheel Clamping System C - SICE S 65 E Manual De Instrucciones

USING THE AUTOMATIC WHEEL
Procedure for locking the wheels with the automatic C system:
Centring with front cone
- Fit the wheel on the shaft, sliding it into place until it rests against the flange.
- Fit the most suitable cone on the shaft and insert it into the central hole of the wheel.
- Fit the locking device by making it slide on the hub until it comes into contact with the
cone.
- Press the control pedal for at least one second.
Centring with rear cone
- Fit the most suitable cone for the central hole of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into place until the cone comes into contact with
the plate that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on the hub until it comes into contact with the
wheel.
- Press the control pedal for at least one second.
Wheel release
- Press the control pedal for at least one second to release the wheel from the flange.
Centring with flanges
Removing the C hub
- Insert the special C key (supplied with the
machine) in the slot of the C hub (fig.11);
- Completely unscrew the C hub;
- Mount the flange on the shaft and lock it in
place with the two screws (A, fig.12) using
the CH 6 wrench.
- Lock the wheel onto the flange as usual.
Assembling the C hub
To reassemble the C hub, proceed as follows:
- Hold down the keyboard key
at least 3 seconds to lock the shaft rotates
and bring to the open position, the pneu-
matic cylinder of the clamping device C;
The message A 52 will be displayed on the
monitor.
- insert the split pin (supplied with the
machine) in the cylindrical protection bush
(B, fig.13)
Operator's Manual S 65 E - S 65 E C
CLAMPING SYSTEM C
for
A
11
12
91