Wheel Data Entry - SICE S 65 E Manual De Instrucciones

Wheel data entry for wheel balancers without an ultrasonic sen-
The machine allows for the diameter and distance values to be entered automatically;
the width value can be entered using the keypad.
- Bring the automatic measuring arm into contact with the inner side of the rim (fig.15).
Take great care to position the arm correctly so as to ensure accurate data reading.
- Keep the arm in contact with the rim until the machine has acquired the wheel's diam-
eter and distance values. The following screen appears during this phase:
- if only one measurement is taken, the machine interprets the presence of a rim with
balancing using a clip weight on both sides (Dynamic Balancing Programme)
- moving the arm to the rest position, the machine will set up for the manual WIDTH
entry.
- in this phase, it is possible to perform an additional acquisition of the rim diameter
and distance.
- Measure the width of the rim using the provided calliper (fig. 16).
94

WHEEL DATA ENTRY

15
sor
Operator's Manual S 65 E - S 65 E C
16