Electrical Hook-Up - SICE S 65 E Manual De Instrucciones

(A) Automatic diameter and distance measuring arm
(B) Automatic ultrasonic sensor for measuring the width (optional)
(C) Head
(D) LCD monitor
(E) Control keypad
(F) Side flange holder
(G) Weight tray
(H) Wheel support shaft
(I) Anvil
(J) Wheel guard
(L) Cone holder
(M) Control pedals C
On request, the wheel balancer can be set up by the manufacturer to operate with the power
supply available in the place of installation. The set-up data for each machine are given on
the machine data plate and on a special label attached to the power supply connection cable.
CAUTION
Any operations for hooking up to the workshop electrical board must be carried out only
by qualified technicians in compliance with the regulations in force, under the respon-
Operator's Manual S 65 E - S 65 E C
Main working parts

ELECTRICAL HOOK-UP

8
81