SICE S 65 E Manual De Instrucciones página 78

Installing the wheel guard with the corresponding mounting
- Install the bush (A, fig. 5) on the rotation pivot (B, fig. 5). While doing this, ensure that
the groove on the pivot is aligned with the pin in the bush;
- Fasten the tube on the pivot using the M12 screw supplied.
- insert the metal tube (D, fig. 5a) into the two plastic guard front holes (C, Fig. 5a);
- Couple the guard to the rear side of the tube by inserting it into the correct position
with snap-in coupling (E, Fig. 5a);
- Secure the wheel guard by tightening the screw provided (F, Fig. 5a).
78
3b
5
Operator's Manual S 65 E - S 65 E C
B
A
G
3c
5a